This machine to produce J trim, which is used to cap the top edges of skirting, the top and sides of doors, the bottom and sides of windows, and in many cases the top of windows for aesthetics and continuity., this lines include 3 tons manual decoiler, roll forming system, hydraulic cutting and finished tables.
Items |
Specifications |
|
Material of coil |
Material Thickness |
0.3-0.8mm galvanized sheet full hard 85-95, G550, PPGI |
Forming system |
Rolling Speed |
0-10 m/min( without the cutting time) |
|
Roller Stations |
About 16-18 stations |
|
Roller Material |
45# Steel with quenching 60mm shaft
|
|
Maim Motor Power |
5.5 kw |
|
Hydraulic cutting Power |
4 kw |
|
Bearing |
Rubber sealing bearing |
Cutting system |
Material Of Cutting |
CR12 with quench treatment |
|
Hardness |
HRB 85-95 |
|
Tolerance |
+-1.5mm |
|
Cutting way |
Stop cutting |
Electrical control system |
Electric Source |
220V, 60HZ,3 phase Also can satisfy Customer’s require |
|
Control System |
PLC Delta |
|
Inverter |
Delta |
|
Weight |
About 2.5 tons |
|
Way Of Drive |
1 inch single chain |
|
Size of machine |
Length 7500mm* Width 800mm* Height 500m |
|
MOTOR |
Under the frame of the machine |
Machine list |
3 ton passive de-coiler |
1 set |
|
Main roll forming machine |
1 set |
|
Cutting device |
1 set |
|
PLC Control box |
1 unit |
|
Hydraulic station |
1 unit |
|
Out table |
1 unit |
The use of these 'J' Channels has long been helpful in interior applications, such as drywall and interior cladding terminations.
J-channel flashing is designed specifically for trimming out openings to allow them to blend seamlessly, and it hides the cut lines of panels. Made from steel, J-Channel is used for receiving siding along doors, windows, eaves and the edges of gables.